Understanding Light Flash Indications¶

Overview¶

Keilton+autani fixtures communicate status through flash patterns. Understanding these patterns helps you confirm successful operations and troubleshoot problems efficiently.

Flash Pattern Categories¶

Category	Pattern Type	Meaning
Success	Slow flash	Operation completed successfully
Failure	Quick flash	Operation failed
Process	Cycling on/off	Operation in progress
Connection	Reboot	Network connection established

Slow Flash Patterns (Success)¶

3 Slow Flashes¶

Indicates successful completion of:

Operation	Result
IR remote disable BLE signal	Success
IR remote enable BLE signal	Success
IR remote reset to factory	Success
Delete lights from app	Success
Manual reset to factory	Success
OTA firmware update	Success
Delete from group	Success
Add to group	Success
Add schedule	Success
Add scene	Success
Delete scene	Success
Bind to switch	Success

1 Slow Flash¶

Operation	Result
Sensor settings applied	Success

Quick Flash Patterns (Failure)¶

10 Quick Flashes¶

Indicates failure of:

Operation	Issue
OTA firmware update	Update failed
Auto calibration	Calibration failed

Action: Retry operation. For calibration, see troubleshooting in V42.

3 Quick Flashes¶

Operation	Issue
Add schedule	Incorrect parameters

Action: Review schedule settings and correct parameters.

Cycling Patterns (In Progress)¶

On/Off 4-8 Times¶

Operation	Status
Auto calibration	Self-learning in progress

Note

This is normal behavior, not an error. Wait for completion.

Reboot Pattern¶

Light Restarts¶

Operation	Status
Add lights to network	Connection established

Note

Normal behavior when joining mesh network.

No Indication¶

Scenario	Meaning
Schedule failure (other reasons)	Failed but no flash
Light offline	Not receiving commands
Out of range	Not connected to mesh

Action: Check app for error messages; verify power and connectivity.

Complete Flash Reference¶

Operation	Indication
IR remote disable BLE	Slow flash 3x
IR remote enable BLE	Slow flash 3x
IR remote factory reset	Slow flash 3x
Add lights	Reboot
Delete lights	Slow flash 3x
Manual factory reset	Slow flash 3x
OTA update success	Slow flash 3x
OTA update failure	Quick flash 10x
Delete from group	Slow flash 3x
Add to group	Slow flash 3x
Add schedule (success)	Slow flash 3x
Add schedule (bad params)	Quick flash 3x
Add schedule (other fail)	No indication
Add scene	Slow flash 3x
Delete scene	Slow flash 3x
Bind to switch	Slow flash 3x
Auto calibration process	On/off 4-8x
Auto calibration failure	Quick flash 10x
Sensor settings applied	Slow flash 1x

Troubleshooting by Pattern¶

Seeing Quick Flashes¶

Pattern	Issue	Solution
10 quick after OTA	Firmware update failed	Retry update
10 quick after calibration	Calibration failed	Retry in different conditions
3 quick after schedule	Bad parameters	Review schedule settings

No Response¶

Observation	Issue	Solution
No flash at all	Light offline	Check power
No flash at all	Out of mesh range	Check connectivity
Command sent, no response	Network issue	Verify mesh connection

Unexpected Cycling¶

Pattern	Likely Cause	Action
Continuous on/off	Calibration in progress	Wait for completion
Random cycling	Possible interference	Check for conflicts

Quick Interpretation Guide¶

What You See	What It Means
3 slow flashes	Success! Operation completed.
1 slow flash	Sensor settings saved.
10 quick flashes	Failure. Retry needed.
3 quick flashes	Schedule parameter error.
On/off cycling	Calibration in progress.
Light reboots	Network connection made.
No response	Check power/connectivity.